37
• Inside of oven: The oven should
always be cleaned after use when it
has cooled down. The cavity should be
cleaned using a mild detergent solution
and warm water. Suitable proprietary
chemical cleaners may be used only
on enamel after rst consulting the
instructions supplied with the oven
cleaner and testing a small sample
on the oven cavity. Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface.
NOTE: The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning.
Let the oven cool down and pay
special attention not to touch the
hot heating elements inside the
oven cavity.
ASSEMBLY AND DISMANTLING OF
THE SIDE RUNNER FRAMES
• Fit the side runner frames into the
holes on the side walls inside the
oven (fig. 8.1).
• Slide into the guides, the shelf and
the tray (fig. 8.2).
• The rack must be fitted so that the
safety notch, which stops it sliding
out, faces the inside of the oven; the
guard rail shall be at the back.
• To dismantle, operate in reverse
order.
OVEN TRAY
The oven tray must be inserted into the
side runners (fig. 8.2).
Fig. 8.1
Fig. 8.2
Guard rail
Stop notch
To Next Page
Loading...
