6. To eliminate residues of the solution and lime scale, rinse
the tank well and ll it with clean water (without des-
caler).
7. Rotate the selector dial to the position and operate
the appliance until the tank is completely empty;
8. Repeat operations 6 and 7 again.
Technical data
Mains voltage: ........................................ 220-240V~50/60Hz
Absorbed power: .........................................................1100W
Pressure: ....................................................................... 15 bar
Water tank capacity: ..................................................1.4 litres
Dimensions LxHxD .............................255x315x280 (395) mm
Weight ...........................................................................3.9 kg
The appliance is in compliance with the following
CE Directives:
amendments.
-
ments.
with food stus are in compliance with the provisions of
the 1935/2004 European Standard.
None of the components of the appliance can
be washed in a dishwasher.
Problem Possible cause Solution
Espresso coee does not ow out No water in the tank Fill the water tank
The holes in the lter-holder are
blocked
Clean the holes in the lter-holder spouts
The espresso boiler outlet is blocked Clean as indicated in the “Cleaning the boiler
outlet” paragraph
Espresso coee drips from the ed-
ges of the lter-holder instead of
through the holes
The lter-holder is inserted incorrectly Attach the lter-holder correctly and turn it fully
home rmly
The espresso boiler gasket has lost
elasticity
Replace the espresso boiler gasket. Contact
De’Longhi Customer Experience
The holes in the lter-holder spout are
blocked
Clean the holes in the spouts
The espresso coee is cold The espresso OK light is not on when
the coee dial is rotated to coee
delivery
Wait for the OK light to switch on
Pre-heating has not been carried out Pre-heat as indicated in the paragraph “How to
Prepare Espresso Coee”
The cups have not been pre-heated Pre-heat the cups using hot water
use
en
troubleshooting
To Next Page
Loading...
