DeLonghi EC155 - Cleaning and Maintenance; Other Cleaning Operations; Descaling; Technical Data

10
 -
presso boiler outlet (g. 28);
 
 
 
Check that the holes are not blocked. If this is not the case,
clean them using a pin.

the tap, rubbing con-
tinuously.
  
outlet, paying attention
to position it correctly
on the gasket (g. 29).
The warranty is not valid
if the cleaning opera-
tions described above
are not performed on a regular basis.
Other cleaning operations
1. Do not use solvents or abrasive detergents to clean the
machine. Use a soft, damp cloth.
2. Clean the lter-holder cup, the lters, drip tray and water
tank regularly.
Danger!
During cleaning, never immerse the machine in water: it is an
electric appliance.
Descaling
It is essential to descale the machine about every 200 coees
particularly in hard water areas. It is recommended to use
De’Longhi descaler that can be found on the market.
Follow this procedure:
1. Fill the tank with the descaling solution obtained by dilut-
ing the descaler with water on the basis of the indications
given on the pack.
2. Rotate the selector dial to the position and wait until
the OK indicator light comes on.
3. Make sure that the lter holder is not attached and posi-
tion a container under the machine outlet.
4. Rotate the selector knob to the position (g. 8) and
and allow about 1/4 of the solution contained in the tank
to ow out: every now and again turn the steam dial and
allow a small amount of solution to escape; then interrupt
by pressing the button again and leave the solution to act
for about 5 minutes.
5. Repeat point 4 another 3 times, until the tank is com-
pletely empty.
6. To eliminate residues of the solution and lime scale, rinse
the tank well and ll it with clean water (without des-
caler).
7. Rotate the selector dial to the position and operate
the appliance until the tank is completely empty;
8. Repeat operations 6 and 7 again.
Technical data
Mains voltage: ........................................ 220-240V~50/60Hz
Absorbed power: .........................................................1100W
Pressure: ....................................................................... 15 bar
Water tank capacity: ..................................................1.4 litres
Dimensions LxHxD .............................255x315x280 (395) mm
Weight ...........................................................................3.9 kg
The appliance is in compliance with the following
CE Directives:
      
amendments.
 -
ments.
 
with food stus are in compliance with the provisions of
the 1935/2004 European Standard.
use
29