Why does my DeLonghi ECP33.21 Coffee Maker switch off seconds after I turn it on?
If your DeLonghi Coffee Maker switches off a few seconds after being switched on, the mode selector dial is not in the I position (Standby). Turn the mode selector dial to the I position (Standby), then press the ON/OFF switch.
Why is the coffee froth from my DeLonghi ECP33.21 too dark?
If the coffee froth from your DeLonghi Coffee Maker is too dark and delivered too slowly, it could be due to several factors. You might be pressing the pre-ground coffee down too firmly; try pressing it less firmly. Alternatively, there might not be enough pre-ground coffee, so reduce the quantity. The espresso boiler outlet could also be blocked, requiring cleaning as described in the section “Cleaning the boiler outlet”. The filter might be blocked, so clean it as described in the section “Cleaning the coffee filters”. Also, the pre-ground coffee might be too fine or damp; use only pre-ground coffee for espresso coffee makers and make sure it is not damp. Finally, you might be using the wrong type of pre-ground coffee; try a different type.
Why is no milk froth forming when making cappuccino with my DeLonghi Coffee Maker?
If no milk froth is formed when making cappuccino with your DeLonghi Coffee Maker, consider these possible causes: * For Model ECP35.31, ensure the ring is in the “CAPPUCCINO” position, not the “HOT MILK” position. * The milk might not be cold enough; always use milk at refrigerator temperature. * The cappuccino maker could be dirty; clean it as described in the section “Cleaning the cappuccino maker”. * Scale in the water circuit could be the problem; descale as described in the section “Descaling”.
Why is no espresso coffee delivered by my DeLonghi ECP33.21?
If no espresso coffee is delivered by your DeLonghi Coffee Maker, there might be several reasons. The water tank could be empty, so refill it with water. Alternatively, the holes in the filter holder might be blocked, requiring you to clean them. Another possibility is a blockage in the espresso boiler outlet, which you should clean as described in the Cleaning section. Lastly, scale in the water circuit can also cause this issue, so descale the appliance as described in the Descaling section.
Why is the pump on my DeLonghi Coffee Maker so noisy?
If the pump of your DeLonghi Coffee Maker is excessively noisy, it could be due to a few reasons. The water tank might be empty, so fill it up. Alternatively, the tank might not be correctly in place, and the valve on the bottom is not open; press the tank down lightly to open the valve. There might also be air bubbles in the tank connector; follow the instructions given in the “Hot water” section until water is delivered.
Why is the espresso coffee from my DeLonghi ECP33.21 cold?
If your DeLonghi Coffee Maker is delivering cold espresso coffee, several factors could be at play. First, ensure the OK light is on when the coffee is delivered; wait until it illuminates. Insufficient preheating could also be the issue; pre-heat as indicated in the “Tips for a hotter coffee” section. Also, make sure you pre-heat the cups with hot water. Finally, scale in the water circuit can cause this; descale as described in the section “Descaling”.
What to do if espresso coffee drips from the edges of the filter holder on my DeLonghi Coffee Maker?
If the espresso coffee from your DeLonghi Coffee Maker drips from the edges of the filter holder instead of the holes, the filter holder may be inserted incorrectly or is dirty. Attach the filter holder correctly and rotate firmly as far as it will go. Another possible cause is that the espresso boiler gasket has lost elasticity or is dirty; in this case, have the espresso boiler gasket replaced by Customer Services. Lastly, the holes in the filter holder spouts may be blocked; clean the filter holder spout holes.
Specific safety instructions for European users regarding age and supervision.
Specific safety instructions for European users regarding age and supervision.
General| Type | Espresso Machine |
|---|---|
| Model | ECP33.21 |
| Power | 1100 W |
| Pump Pressure | 15 bar |
| Color | Black |
| Voltage | 220-240 V |
| Material | Stainless Steel |
| Special Features | Self-priming system |
| Water Tank Capacity | 1.1 L |
To Next Page
