If the room temperature exceeds the selected temperature level,
the appliance will switch off (fig. 3D).The heater will switch back
on automatically when the room temperature falls below the
selected temperature level.
If medium power level has been selected using the button, and
the thermostat set, the heater will modulate between the medium
and minimum power levels.As with the maximum power setting, if
the room temperature exceeds the selected temperature, the appli-
ance will switch off, and then on again when the temperature falls.
(For models with timer, ensure that the switch on the timer dial
(as shown in description) is in position 1, manual.
NOTE: if the timer switch is at the 0 position (fig.4), the heater is
off and will not operate).
Frost stat function
Press the button, it is recommended to select maximum power
level.
Set the thermostat dial to the “ “ position (fig. 4).
When set in this way, the appliance will switch on automatically
only if the room temperature falls below 5°C, to prevent freezing,
at minimum energy consumption.
This function is not guaranteed in the event of power failures, even
if lasting just a few seconds.
Models with turbo fan boost (as shown in decsription)
A number of models have a turbo fan boost for even more rapid
and uniform heating.To use this function, press the switch on the
fan grill.
Cool air ventilation
To operate the fan only for “cool air” ventilation, ensure that ECC
is off and turn the thermostat to the maximum then press the
switch on the fan grill.
Using the timer
If you wish to use the timer, position the switch in the middle posi-
tion (Fig.5)
1= Manual (timer override)
= Timed operation
0 = Heater off
Setting the correct time
Check the time on your watch. If for example it is 4.00 pm.
(16.00), turn the dial in a clockwise direction until the number 16
Electric Heating Convector HCA
5
*
Fig.5
To Next Page
Loading...
