6
5. High power operation: turn the function selector to po-
sition 2 (the fan operates at maximum).
6. Switching o: turn the function selector to the “0” posi-
tion.
Setting the thermostat
Position the thermostat on maximum. When the room has
reached the required temperature, turn the thermostat dial
slowly counterclockwise until you hear a click and the fan
goes o. The thermostat will then keep room temperature at
the selected level automatically.
Frost prevention mode
With the function selector in position 2 and the thermostat
dial in position , the appliance maintains room tempera-
ture at about 41°F (5°C), preventing freezing with minimal
energy consumption.
MAINTENANCE
- Always unplug from the outlet before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the
appliance.
SAFETY FUNCTIONS
- Safety device: the appliance is tted with a safety
device that switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn’t work please contact the
De’Longhi Customer Service.
- Tip-over safety device: certain models are tted
with a tip-over switch (D) which turns the appliance o
if it falls over. To restart the appliance, simply place it
upright again.
PROBLEM CAUSE SOLUTION
The appliance doesn’t work Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The function selector is in the ”0” po-
sition.
The thermostat may be set too low.
Plug into the outlet.
Remove the obstruction, unplug the
heater and let the appliance cool down.
If the appliance doesn't work please
contact the De longhi toll free number.
Turn the function selector to the position
or “1” or ”2”.
Turn the thermostat clockwise to a higher
setting until the heater restarts.
The tip-over switch has been activated
(certain models only).
Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you.
TROUBLESHOOTING
To Previous Page
Loading...
Need help?
General