DeLonghi MAGNIFICA - Electrical Requirements

2
Electrical requirements
Before using this appliance ensure that the voltage indicated on the prod-
uct corresponds with the main voltage in your home, if you are in any
doubt about your supply contact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of
13 amp capacity. Should this plug not fit the socket outlets in your home, it should be
cut off and replaced with a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be
properly disposed of and not left where children might find it and plug it into a supply
socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that can be
switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are coloured in accor-
dance with the following code:
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal in
the plug which is marked with the letter E or by the earth symbol or coloured
green or green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained in each ter-
minal. Do not forget to tighten the mains lead clamp on the plug. If your electricity
supply point has only two pin socket outlets, or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require replacement, it is essential that this operation be
carried out by a qualified electrician and should only be replaced with a flexible cord
of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse
cover is lost, the plug must not be used until a replacement cover is obtained. The
colour of the correct replacement fuse cover is that of the coloured insert in the base
of the fuse recess or elsewhere on the plug.Always state this colour when ordering a
replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio
interference.
Warning - this appliance must be earthed
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp