1x
26
14
Seing the coee volume
1. The programming of the coee volume is specific to each capsule type:
Espresso, Double Espresso, Gran Lungo, Mug or Carafe.
2. Open the machine, insert the capsule you want to program; close the ma-
chine; turn the lever towards the locked position . The light will blink
while the machine is heating up. A steady light indicates that the machine
is ready.
3. Then press and hold the buon until the desired volume is reached.
4. The new coee volume is now stored for the capsule type used during the
seing.
Note: once a customer-specific volume is programmed by the user, every
time that capsule type is inserted in the machine, the preparation will keep to
the user-programmed cup size.
Note: if you wish to return to the default parameters see the paragraph
“Reset to factory seings”.
15
Reset to factory seings
1. Plug in the power cord.
2. Make sure that no accessory (milk carafe or descaling pipe) is connected
to the milk carafe connector hatch. Turn on your machine.
1x
To Next Page
Loading...
Need help?
General
