DeLonghi PAC N135E - Preparing for Use: Electrical and Window Setup; Electrical Connection Requirements; Window Exhaust Installation

5
Preparing for use
en
ELECTRICAL CONNECTIONS
Before plugging the appliance into the electrical receptacle,
check that:
• The outlet’s power supply corresponds to the value
indicated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• Theoutletisa3-holegroundedoutlet.Ifthisisnot
the case, you must choose another outlet.
Failure to follow these important safety instructions
absolves the manufacturer of all liability.
The power cable must be replaced by a qualied
professional only.
The instructions below will enable you to prepare your air
conditioner for operation as eciently as possible. Before
use, make sure the air intake and outlet grilles are
unobstructed.
AIR-CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your comfort is ensured with your
air conditioner:
• Screwthehoseadaptor13tothehose’send 12.
• Fittheairexhausthoseinthehousingatthebackofthe
appliance. Insert it as shown in gure A.
• Screw the window outlet  17 to the other end of the
exhaust hose. (see g. B).
Sash window
• Openthewindow.
• Placethewindowbracket 15 in the window, extending it
to t the width of the window (g. C).
• Place the air conditioner near the window. Insert the
assembled exhaust hose 12 into the window bracket hole
15.
• Makesuretheairexhausthoseisunobstructed.
• Ifyouhaveaverylargewindow,inordertocoveryour
window aperture, use the additional window bracket
without holes extending it to the desired dimension,
then x the bracket by using the locking pin provided.
Whenextractingthewindowbracketandjoiningthetwo
pieces pay attention you do not cover the hole.
Other set-up methods:
• Thankstothelockingpin,it’spossibletousethewindow
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust
hose (see gure D).
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
A
B
C
D