tracted and emptied (fig. 12). When the tank
has been emptied and replaced, the applian-
ce starts up again.
PUMP OPTION
-
ted moisture upward out a window or into a
drain, this eliminates the need to empty the
tank during dehumidification. Simply con-
nect the drain tube as shown in fig. 13.fig.
13.
Note: In order for the continuous pump system
to operate correctly, ensure the tube is properly
AIR PURIFYING/FAN MODE (FIG. 14)
When using the appliance in this mode, the air
exhaust hose does not need to be attached.
MODE button a number of times
until the fan symbol (5) appears.
FAN button.
Quiet speed: for quiet operation.
High speed: for maximum fan po-
wer;
Medium speed: reduces noise le-
vels but still maintains a good level
of comfort;
High speed: for maximum fan power;
In this mode, AUTO speed cannot be selected.
HEATING MODE (FIG. 15)
When going from heating to cooling mode, the
unit will need 3-5 minutes before producing
until the heating symbol (6) appears.
the + or - button until the corresponding va-
lue is displayed.
automatically by the appliance.
Water is removed from the air and collected in
the tank at the back of the air conditioner.
When the tank is full, the appliance shuts down
tank must be extracted and emptied (fig. 12).
When the tank has been emptied, the appliance
13
14
11
12
To Next Page