DeLonghi SCF 1000 User Manual

11
Read this manual thoroughly before installing and using the appliance. This is the only way to
ensure the best results and maximum safety for the user. Save these instructions for future refe-
rence.
1. After removing the packaging, make sure the product is complete and undamaged. If in
doubt, do not use the appliance and contact professional personnel or an authorised servi-
ce centre only. Do not leave packaging elements within reach of children as they could be
dangerous.
2. Never use the appliance if the cable is damaged.
3. This appliance must be used exclusively for the purposes for which it was specifically inten-
ded, namely, to dry bath towels and clothes. Any other use is considered improper and thus
dangerous. The manufacturer cannot be held responsible for any damage caused by impro-
per, erroneous and unreasonable use. Take special care when using the appliance with par-
ticularly delicate garments (wool, silk, nylon, etc).
4. The use of all electrical appliances implies the observance of some fundamental rules, in par-
ticular:
- NEVER TOUCH the appliance with wet or damp hands or feet;
- PROTECT the appliance from atmospheric agents;
- NEVER ALLOW the appliance to be used by children or unfit persons without surveillance;
- NEVER UNPLUG by pulling the power cable;
5. If the socket and power cable plug are incompatible, the socket should be changed by qua-
lified personnel only.
6. When the appliance is to be discarded, after unplugging from the mains, the lead should be
cut to make the appliance unusable.
7. Never use accessories or devices other than those provided by the manufacturer.
8. Never overload the appliance.
9. Never cover with dripping wet items.
10.For all technical operations, including replacement of the power cable, contact authorised
service centres only to avoid all risk
11.Never direct jets of water directly at the appliance. NEVER IMMERSE IN WATER.
12.In the event of accidental overheating (for example if the air intake and outlet grills are
obstructed, the motor is not functioning correctly, etc) a safety device interrupts operation of
the convection heater. To reset operation, unplug from the mains for a few minutes, elimina-
te the cause of the overheating and then plug in again.
13.Important: accidental resetting of the safety system could be dangerous. To avoid this, never
power the appliance through an external timer.
Important: under no circumstances should the top of the appliance (convection
heater) be covered as this would cause the heater to overheat dangerously.
- Before plugging in, make sure the voltage of your household mains supply corresponds to the
voltage indicated on the appliance.
- Make sure the rating of the socket is adequate for the data given on the appliance rating plate.
THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC AND D.M. 476/92 ON ELEC-
TROMAGNETIC COMPATIBILITY.
IMPORTANT WARNINGS
ELECTRICAL CONNECTION
GB

DeLonghi SCF 1000 Specifications

General

Brand	DeLonghi
Model	SCF 1000
Category	Heater
Language	English

Summary

Important Warnings

Packaging and Initial Check

Check product completeness and condition after unpacking. Contact professionals if unsure.

Damaged Cable Usage

Never use the appliance if the power cable is damaged.

Intended Use and Risks

Use exclusively for drying towels/clothes. Other uses are dangerous and void responsibility.

General Electrical Safety Rules

Follow fundamental electrical safety rules, e.g., avoid wet hands, protect from elements.

Socket and Cable Compatibility

Ensure socket compatibility; change by qualified personnel if needed.

Appliance Disposal

Cut the lead after unplugging to make the appliance unusable upon disposal.

Approved Accessories Only

Only use accessories or devices provided by the manufacturer.

Overloading the Appliance

Never overload the appliance.

Dripping Wet Items

Never cover the appliance with dripping wet items.

Technical Operations

For technical operations, contact authorized service centers only.

Water Usage Precautions

Never direct water jets at the appliance; never immerse it in water.

Overheating and Resetting

Safety device interrupts operation on overheating. Reset by unplugging and clearing cause.

Safety System and External Timers

Avoid accidental safety system reset by not using external timers.

Covering the Heater

Never cover the top heater to prevent dangerous overheating.

Electrical Connection

Installation

Safety Distances and Positioning

Respect specified safety distances and position appliance to avoid touching controls.

Clearance Requirements

Keep appliance at least 50cm from inflammable objects and 30cm from ceiling.

Socket Placement

Ensure the socket used is outside safety distance indicators.

Professional Installation

If necessary, have the appliance installed by a qualified person.

Location Selection

Identify a suitable location respecting safety distances and ensuring easy access to electrical devices.

Wall Preparation

Before drilling, check the wall for wires or pipes.

Mounting Brackets

Use provided brackets, screws, and anchors to fix the towel warmer to the wall.

Drilling and Fixing

Drill holes using template, fix brackets, hang warmer, adjust, and secure with screws.

Final Installation Steps

Re-hang, fix with screws, and fit covers. Ensure plug accessibility.

Description of Display

Timer Mode Display

Shows display elements for functioning in timer mode, including time settings and indicator lights.

Manual Mode Display

Shows display elements for functioning in manual mode, including appliance status and symbols.

Operation and Use

Setting the Clock

Instructions on how to set the appliance's clock using the 'Clock Set' button.

Manual Mode Operation

Explains how to turn the appliance on/off and switch between heated rail and convection heater.

Thermostat and Mode Adjustments

Adjusting the Thermostat

Instructions for setting the thermostat to regulate room temperature.

Frost Protection Function

Utilizes the frost protection function to maintain a minimum room temperature.

Hair Drying Function

Enables the 'Hair Drying' mode by turning the thermostat knob to MAX.

Automatic Mode (Timer)

Programming Heated Rail

Procedure for programming automatic start-up times for the heated rail (P1, P2).

Programming Convection Heater

Procedure for programming automatic start-up times for the convection heater (P3, P4).

Automatic Mode Notes

Details on OFF time settings, inactive programmes, and symbol indications.

Maintenance