13
1. Setting the clock
When connecting to the mains for the first time or each time the mains supply comes back on,
"
00:00
" flashes on the display.
You can now set the clock by pressing the "Clock Set" button and proceeding as follows:
• single pressure of the "Clock Set" button the clock goes forward one minute;
• first 20 seconds of continuous pressure the clock goes forward slowly;
• continuous pressure after 20 seconds the clock goes forward fast.
While the time is being set, the display flashes.
Once setting has been completed, the flashing continues for several seconds, then indicates the
exact time steadily. The clock starts operating.
To set the clock again, just hold the "Clock Set" button down for several seconds until the time
display starts to flash The time can now be set following the instructions described above.
Functioning in manual mode
When connecting to the mains for the first time or each time the mains supply comes back on, the
appliance is in manual mode ("MAN" displayed at the top right). The appliance is off ("0" displa-
yed at the bottom left).
Pressing the "MAN" button once turns the towel warmer on (" " appears on the right of the dis-
play and the "ON" light comes on).
Pressing the I "MAN" button again deactivates the heated rail and turns power to the convection
heater on (" " appears on the right of the display and the "ON" light is on).
Pressing the I "MAN" button again turns power to both the heated rail and convection heater on
(" " and " " appear on the right of the display and the "ON" light is on).
Further pressing of the I "MAN" button returns the appliance to the original state (appliance off and
"0" on the display).
DESCRIPTION OF DISPLAY
OPERATION AND USE
To Next Page
Loading...
