DeLonghi TCH8093ER User Manual

4
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
Symbols used in these instructions
Important warnings are identied by the symbols below.
It is important to respect the warnings. Failure to respect
the warnings could lead to electric shock, serious injury,
burns, re or damage to the appliance.
Danger!
Failure to observe the warning may result in life
threatening injury by electric shock.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or
scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
Safety functions
- Safety device: the appliance is tted with a safety
device which switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset,
unplug the appliance from the mains socket for a few
minutes, remove the cause of overheating then plug
in again.
- Tip over safety device: a tip over safety device
turns the appliance o if it falls over or is positioned
inappropriately in such a way as to jeopardise safety.
The appliance emits a beep and a dot ashes on the
display. The appliance resumes operation a few se-
conds after being placed in an upright position again.
DESCRIPTION
(see g. 1)
A ON/STAND-BY button
B +/- adjustment buttons
C MODE button (selects the operating mode)
D “ECO plus” button
E Timer button
F Swing button
G Remote control receiver
H Indicator light
I Air intake grille
J Filter
USE
Installation
- The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the
same socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to
the value indicated on the rating plate and that the
mains power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE
2004/108/EEC ON RADIO INTERFERENCE
SUPPRESSION.
Mounting the base
- Fit the two parts of the base together, matching the
guide pins on the front with the recesses on the back
and snapping the two clips into place (g. A and g. B).
- Turn the appliance upside down and position the
assembled base on the appliance in order to couple
the two openings with the two tabs on the appliance,
tilting it as shown in gure C, consequently turn the
base down till the two frontal teeth snaps into position.
Operation and use
1. Plug into the mains socket.
2. The appliance emits a beep. The indicator light (H)
comes on and remains lit while the appliance is
powered.
3. The appliance switches to stand-by. A dot ashing
on the display means the tip over device has been
activated. See paragraph: “Safety functions”.
4. Press the ON/STAND-BY (A) to turn the appliance on.
It begins heating the room according to the current
settings.
5. Press the MODE button (C) to select one of the
following operating modes:
Fan
Freeze prevention
Heating 1

DeLonghi TCH8093ER Specifications

General

Type	-
Heating power	2400 W
Heating power (min)	800 W
Adjustable thermostat	Yes
Suitable for room volume up to	70 m³
Product color	Black, White
Placement options	Floor
Heat source	Electric
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	269 mm
Width	275 mm
Height	695 mm