Set/select channel presets
Your SKYFi Receiver can store up to 20 preset
channels. They are organized into two differ-
ent groups, or memory banks, Preset A and
Preset B, each with 10 channels corresponding
to the 10 number keys.
Setting channel presets
1. Tune in the channel you want to register
as a preset.
2. Select either Preset A or Preset B by
pressing until an A or B appears in
the upper right corner of the display.
3. Press and hold the number key correspon-
ding to the preset you would like to set. The
channel name and number will highlight
and the audio will mute for 2 seconds to
indicate that the preset is registered.
Selecting channel presets
Press until an A or B appears in the upper
right corner of the display. Press the number
key corresponding to the desired preset.
Tune to a channel
Tune up and down the channel list using
the SKYFi scroll wheel or the
buttons on the remote.*
Skip channels in the lineup using the Channel
Skip/Add function described in Section 4,
“Menu Commands and Settings.” This
will allow you to tune across only the XM
channels you listen to regularly.
*When SKYFi is connected to the SKYFi Audio System,
these buttons control the volume, and other channel-
selection methods should be used.
8
Section 3
To Next Page
Need help?
General
