EasyManua.ls Logo

DELTA BREEZ SIG80 - User Manual

DELTA BREEZ SIG80
13 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
READ AND SAVE THESE INSTRUCTIONS
Address: 46101 Fremont Boulevard, Fremont, CA 94538
US
Toll Free Number: 1-888-979-9889
www.deltabreez.com
V01
TABLE OF CONTENTS
Package Contents 2
General Safety Information 3
Preparation and Wiring Diagrams 4
Assembly Instructions - New Construction 5
Assembly Instructions - Existing Construction 6
Grille Installation 10
Operation 10
Care and Maintenance 11
Troubleshooting 12
Dimensions 13
Product Specications 13
Warranty 14
VENTILATION FAN
MODEL SIG80 / SIG80M / SIG80D / SIG110 / SIG110H / SIG110D

Table of Contents

Questions and Answers

  • F
    Fred SmithJul 28, 2025
    Why is my DELTA BREEZ SIG80 so loud?
    • K
      kristaelliottJul 28, 2025
      There could be several reasons why your DELTA BREEZ Fan is louder than expected: * The CFM (cubic feet per minute) rating may be too high for the room size. Ensure the fan's CFM rating matches the room's requirements. * The damper might not be working correctly or could be damaged. Check that it opens and closes properly. If damaged, contact Customer Service. * A sharp bend in the duct might be too close to the fan discharge (less than 18 inches). * The ducting might be smaller than recommended, increasing noise. Use the recommended size ducting. * The fan body might not be securely attached to the ceiling joists. Make sure it's firmly attached.
  • M
    Melissa BurchAug 6, 2025
    What to do if DELTA BREEZ Fan is not clearing the room?
    • M
      Michael RobinsonAug 6, 2025
      If your DELTA BREEZ Fan isn't clearing the room effectively, it might be due to: * Insufficient airflow within the room. Ensure a door or window is slightly ajar or open to allow air to flow in. The fan needs sufficient intake airflow to draw air out of the room. * Insufficient CFM (cubic feet per minute). Verify that the fan's CFM rating matches the requirements for your room size.
  • J
    jerryhendersonAug 17, 2025
    How to fix a DELTA BREEZ SIG80 Fan that is not turning on?
    • C
      Cindy ShortAug 17, 2025
      If your DELTA BREEZ Fan isn't turning on: * Ensure that the power supply is on. * Test or replace the switch. * Check the wiring in the switch box.

Summary

Package Contents

General Safety Information

Preparation

Wiring Diagrams

Explains electrical connections for different fan models.

Assembly Instructions

New Construction

Steps for installing the fan during new construction, attaching to joists.

Existing Construction

Guide for installing the fan in existing structures, accessible from above.

Install from Below

Instructions for installation from below, without needing suspension brackets.

Installation with Suspension Brackets

Method for installing the fan using suspension brackets, for attic access.

Grille Installation

Operation

Fan Operation Modes

Details on single speed, motion, humidity, and dual speed operation.

Care and Maintenance

Troubleshooting

Dimensions

Product Specifications

DELTA BREEZ SIG80 Specifications

General IconGeneral
Airflow80 CFM
Noise Level0.3 Sones
Duct Size4 inches
Frequency60 Hz
ENERGY STAR CertifiedYes
Mounting TypeCeiling or Wall
Voltage120V
Motor TypeDC Brushless

Related product manuals