Delta Controls Red5-PLUS/EDGE-6 Series User Manual

The information in this document is subject to change without notice.
Embedded Web Server
The simplest way to access the embedded web server is to plug your laptop directly into one of the
controller’s Ethernet ports. This method is preferred.
To connect to the embedded web via a direct connection:
1. Make a note of the serial number listed on the back of the controller.
2. Connect your PC or laptop directly to one of the controller’s Ethernet ports. Make sure nothing else is
connected to the controller’s Ethernet ports (ETH1 and ETH2).
3. Enter https://169.254.178.50 in your browser’s address bar and proceed to the login page.
4. On the login page, under Username, enter Admin, and under Password, enter the controller’s serial
number without the slash (for example, 1234561234).
5. Click Login.
Note: Refer to the Installation Guide for more information on how to connect your controller using other methods.
enteliWEB
To set up your Red5 using enteliWEB, ensure you have a PC with a valid enteliWEB license.
See the online help for more information about setting up your device using enteliWEB.
Configuring the Red5
There are three ways to configure your Red5:
• Proviso App
• Embedded Web Server
• enteliWEB
Proviso App
1. To configure your Red5, go to Settings > Network. If you want to assign a static IP address, select , select
Static, enter the IP settings, then select Save. Otherwise, leave it as DHCP. The IP address must be unique
for each device.
2. Configure a network connection: IP, Ethernet, or Secure Connect.
3. Next to Security, select , enter a 6-digit PIN to secure BLE read/write access to the device, then select
Save.
4. Select Apply settings to device. After the settings are applied, the status shows Configured and a green
check mark appears next to each applied setting.
Embedded Web Server
Refer to the enteliWEB procedures for configuring your Red5 via the embedded web server.
enteliWEB
To configure your Red5 using enteliWEB, see the Configuration topic in the online help.

Delta Controls Red5-PLUS/EDGE-6 Series Specifications

General

Brand	Delta Controls
Model	Red5-PLUS/EDGE-6 Series
Category	Controller
Language	English