To Next PageTo Next Page
Need help?Do you have a question about the Delta Elektronika SM 300-20 and is the answer not in the manual?
General| Output Voltage | 0-300 V |
|---|---|
| Output Current | 0-20 A |
| Efficiency | > 90% |
| Protections | Overvoltage, Overcurrent, Overtemperature |
| Power Rating | 6000 W |
| Voltage Regulation | 0.01% + 2 mV |
| Operating Temperature | 0-50 °C |
| Cooling | Forced air |
| Remote Control | Yes |
General safety precautions, danger of electrical shock, live circuits, and parts substitution.
Guidelines for grounding mains terminals and DC power terminals to prevent shock hazards.
Description of output voltage and current capabilities, including CV/CC settings and protection.
Explanation of CV-load regulation and requirements for accurate CC-load regulation.
Methods for programming output voltage and current using external analog voltages.
Overview of optional PSC-ETH, PSC-488, PSC-232, PSC CAN controllers.
Explanation of the thermal switch and OT status for preventing overheating.
How to use remote sensing to maintain constant voltage at the load, with limitations.
Using Master/Slave feature to combine units into a larger system.
Using voltage and current limits to protect circuits and the power supply unit.
Details on front panel knobs, potentiometers, and digital encoders for control.
Step-by-step guide for initial setup, connections, and powering on the unit.
Connecting and configuring analog voltage sources for output programming.
Using the ISO AMP CARD or CON H for isolated analog programming to prevent earth loops.
Configuring digital interfaces like IEEE488 and RS232 for unit programming.
Connecting sense leads for remote sensing to maintain constant load voltage.
Connecting units in series using Master/Slave mode for higher voltage.
Connecting units in parallel using Master/Slave mode for higher current.
Steps to diagnose and resolve issues where the unit provides no DC output.
Diagnosing problems with programming, including offsets and fuse issues.
Troubleshooting steps for failures related to status outputs and fuses.
