Delta OHM DO 9721 - P9 Self Cut-out Function

ENGLISH
90
KEY SIMBOLS LIT BESIDES
THE NUMBERS
FUNCTION
DESCRIPTION
P9+ =
enable/disable
self cut-out
- P9 -
When ENTER is pressed with P9
on the display, the instrument
enters the program which enables
or disables the self cut-out func-
tion when it is in storage mode
and with a set storage interval
higher than or equal to 1 minute.
The s and t keys are used to
select the value 00 or 01.
00: with a set storage interval
lower than 1 minute, the
instrument does not switch off
automatically; it always
remains lit.
When the ON/OFF key is
pressed, storage stops and
the instrument switches off.
00: with a set storage interval
higher than 1 minute, the
display switches off automati-
cally after about 8 minutes. At
each set storage interval there
is a beep and the display swit-
ches on for a few seconds.
The display can be switched
on or off by pressing the
ON/OFF key. The instrument
keeps on storing if you keep it
switched on. The display swit-
ches off automatically after
about 8 minutes.
To stop storage, press the
ON/OFF key (if the instrument
is off). Press the ENTER key.
01: with a set storage interval
lower than 1 minute, the
instrument does not switch off
automatically.