PHOTO/RADIO/THERMOMETER DATA LOGGER rev.V1 R1
STORED DATA REPORT
DATE TIME ---- A --- ---- B --- ---- A-B --
16-03-2000 11:08:33 80.7 umol/mqs 149.8 umol/mqs - 69.2 umol/mqs
16-03-2000 11:08:43 119.7 umol/mqs 149.9 umol/mqs - 30.2 umol/mqs
16-03-2000 11:08:53 95.6 umol/mqs 149.8 umol/mqs - 54.2 umol/mqs
16-03-2000 11:09:03 106.5 umol/mqs 149.9 umol/mqs - 43.4 umol/mqs
16-03-2000 11:09:13 219 umol/mqs 149.9 umol/mqs 69 umol/mqs
16-03-2000 11:09:23 193.1 umol/mqs 149.9 umol/mqs 43.3 umol/mqs
Maximum Values : 219 umol/mqs 149.9 umol/mqs 69 umol/mqs
Minimum Values : 80.7 umol/mqs 149.8 umol/mqs - 69.2 umol/mqs
Average Values : 135.8 umol/mqs 149.8 umol/mqs - 14.1 umol/mqs
Calibration date 16-03-2000
The above example differs from the previous ones in that it is a report obtained from the stored
acquisitions, at intervals of ten seconds from each other.
------------------------------------------------------------------------------------------------------------------------------------
If a probe should be replaced, with another of a different type, during the serial transmission of the
direct measurements, the transmission will be interrupted and the report will appear as in the example:
PHOTO/RADIO/THERMOMETER DATA LOGGER rev.V1 R1
IMMEDIATE SERIAL REPORT
DATE TIME ---- A --- ---- B --- ---- A-B --
16-03-2000 11:22:26 104.1 umol/mqs 149.8 umol/mqs - 45.8 umol/mqs
16-03-2000 11:22:36 104.1 umol/mqs 149.8 umol/mqs - 45.8 umol/mqs
16-03-2000 11:22:46 104.0 umol/mqs 149.8 umol/mqs - 45.8 umol/mqs
Calibration date 16-03-2000
The highlighted line indicates that the last reading printed cannot be significant, due to the replace-
ment of a probe during the previous interval.
------------------------------------------------------------------------------------------------------------------------------------
!!!!! LAST READING NOT MEANINGFUL: PROBE CHANGED DURING LOG !!!!
109
ENGLISH
To Next Page
Loading...
