HD2102 - 22 - V2.3
MALFUNCTIONING UPON TURNING ON AFTER BATTERY REPLACEMENT
After replacing the batteries, the instrument may not restart correctly; in this case, repeat the
operation. After disconnecting the batteries, wait a few minutes in order to allow circuit condensers
to discharge completely; then reinsert the batteries.
WARNING ABOUT BATTERY USE
• Batteries should be removed when the instrument is not used for an extended time.
• Flat batteries must be replaced immediately.
• Avoid batteries leaking.
• Always use good quality leakproof alkaline batteries. Sometimes on the market, it is
possible to find new batteries with an insufficient charge capacity.
INSTRUMENT STORAGE
Instrument storage conditions:
• Temperature: -25…+65°C.
• Humidity: less than 90%RH without condensation.
• Do not store the instrument in places where:
Humidity is high.
The instrument may be exposed to direct sunlight.
The instrument may be exposed to a source of high temperature.
The instrument may be exposed to strong vibrations.
The instrument may be exposed to steam, salt or any corrosive gas.
The instrument case is made of ABS plastic and the protections are rubber: do not use any
incompatible solvent for cleaning.
To Next Page
Loading...
Need help?
General
