- -
26
11.2 TEMPERATURE PROBES WITHOUT SICRAM MODULE
TP47.100.O Direct 4 wire Pt100 sensor immersion probe. Probe's stem Ø 3 mm, length 230
mm. 4 wire connection cable with connector, length 2 metres.
TP47.1000.O Pt1000 sensor immersion probe. Probe's stem Ø 3 mm, length 230 mm. 2 wire
connection cable with connector, length 2 metres.
TP47 Only connector for probe connection: direct 4 wire Pt100, 2 wire Pt1000 (the
connection instructions are outlined on page 14).
11.3 ACCESSORIES
HD11 Saturated solution at 11.3%RH@20°C for calibration of relative humidity probes,
ring M12×1.
HD33 Saturated solution at 33.0%RH@20°C for calibration of relative humidity probes,
ring M12×1.
HD75 Saturated solution at 75.4%RH@20°C for calibration of relative humidity probes,
ring M12×1.
Protection for humidity probes (thread M24×1.5)
P1 Protection grid in stainless steel for Ø 26 mm probes.
P2 Protection in 20μ sintered polyethylene PE for Ø 26 mm probes.
P3 Protection in 20μ sintered bronze for Ø 26 mm probes.
P4 Complete cap in 20μ sintered polyethylene PE for Ø 26 mm probes.
Protection for humidity probes (thread M12×1)
P5 Protection grid in stainless steel for Ø 14 mm probes.
P6 Complete protection in 20μ sintered AISI 316 for Ø 14 mm probes.
P7 Complete protection in 20μ PTFE for Ø 14 mm probes.
P8 Stainless steel and Pocan grid protection for probes Ø14mm.