EasyManua.ls Logo

Delta UV D-80 - Use and Maintenance; Lamp Cooling and Handling

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2015 Delta Ultraviolet Corporation All Rights Reserved Rev 01/16 P/N 94-35234 Page 9
USE & MAINTENANCE
Allow the ultraviolet lamp to cool for at least 30 minutes before
handling
NEVER LOOK AT THE ULTRAVIOLET LAMPS WHEN LIT.
This may cause severe injuries or burns and may even lead to loss of
eyesight.
Do not touch the ultraviolet lamp with bare hand, as these would leave
impurities that shorten the life of the lamp. If you do touch it clean with
alcohol or white vinegar.
Never unscrew the quartz tube sealing nut when the sanitizer is on load
as the quartz tube could be blown out of the sanitizer with force and will
injure you.
To avoid electric short-circuits; do not place the electric wires or the
sanitizer in the pool water or in any other maintenance or cleaning fluid.
Do not restart the system until the electric unit, the covers exterior
elements of the sanitizer are correctly put back in place. When replacing
the lamp or carrying out annual cleaning of the quartz tube, make sure
that the electrical elements are in place and correctly attached before
switching on the sanitizer.
Do not use the Delta UV sanitizer for any other use than that for which it
was designed. Hg-Lamp CONTAINS MERCURY. For your own safety
manage in accord with disposal laws. Please visit : www.lamprecycle.org
The Delta UV unit comes with all internal components fully assembled and ready for installation. Only the
Inlet/Outlet unions need to be installed to ready your unit for installation.

Related product manuals