Delta AC MAX Smart - Technical Specifications; Charging and Electrical Specifications; Environmental and Physical Specifications

22
AC_MAX_SMART_QIG_EU_V1.0.0_2021-03
Version Smart
Charging mode Mode 3
Charging interface
IEC 62196-2: Type 1 plug, Type 2 plug, Type 2
socket, or Type 2 socket with shutter
Input/output rating
220-240 V
AC
, 1~, 16 A or 32 A max., 50-60 Hz
380-415 V
AC
, 3~, 16 A or 32 A max., 50-60 Hz
Input wiring
Single-phase: L1, N, PE
Three-phase: L1, L2, L3, N, PE/ L1, L2, L3, PE (IT)
Standby power < 5,0 W*
Altitude 2000 m
Internal residual current detection AC 30 mA, DC 6 mA
Surge protection Class II
Electrical protection
Over current protection, short circuit protection,
over voltage protection, under voltage protection,
ground fault protection, surge protection, over
temperature protection
Cold load pick-up
Randomized delay between 5 and 100 seconds
before the charge resume after power outages.
Status indicators Blue, green, red, yellow
Network interface Bluetooth, ethernet, wi, cellular
Charging protocol OCPP 1.6J
Card reader RFID card reader compliant to ISO/IEC 14443 A/B
Operating temperature -30ºC to +50ºC (-22ºF to +122ºF)
Storage temperature -40ºC to +80ºC (-40ºF to +176ºF)
Relative humidity < 95%, non-condensing
Length of charging cable 5 m, straight cable
Ingress protection IP55
Impact protection IK09
Cooling Natural cooling
Dimension (H x W x D)
371 x 218 x 167 mm (14.6 x 8.6 x 6.6 inch), exclu-
ding charging cable, mounting bracket and cable
holder
Net weight
3.9 kg*
Compliance/ certicate CE, UKCA
* Depends on model conguration.