Delta C2000 Plus - Page 15

Chapter 1 Overview of Parallel Control Parallel Control Solution
9
1-3-2 Reactor
During the parallel control, if there is no reactor installed on the output side, some of the current from
the drive flows into the parallel drive and causes circulating current. Install an output reactor can
prevent the above circulating current occurs. Refer to the user manual of each drive models in Delta
Download Center for reactor selections.
⚫ C2000 Plus User Manual (refer to Section 7-4)
https://downloadcenter.deltaww.com/downloadCenterCounter.aspx?DID=22212&DocPath=1&hl=en-US
⚫ C2000-HS User Manual (refer to Section 7-4)
https://downloadcenter.deltaww.com/downloadCenterCounter.aspx?DID=42836&DocPath=1&hl=en-US
⚫ C2000-R User Manual (refer to Section 7-3)
https://downloadcenter.deltaww.com/downloadCenterCounter.aspx?DID=44189&DocPath=1&hl=en-US
Parallel circulating current reactor
Figure 1-2
Parallel Circulating
Current Reactor Delta #
kW
Rated
Current
(A)
Inductance
Value
(μH)
Saturated
Current
(Arms)
Consumption
(W)
Dimension
(mm)
UL
Certification
DR505LP004P
220
505
4.35
757.5
96.2
As shown in
the figure
above
Pass
250
Table 1-9