Delta DVP28SV11R User Manual

- 2 -
 Electrical Specifications
Model
Item
DVP28SV11R DVP28SV11R2 DVP28SV11T
DVP24SV11T2
DVP28SV11T2
DVP28SV11S2
Power supply
voltage
24VDC (-15% ~ 20%) (with counter-connection protection on the polarity
of DC input power)
Inrush current Max. 2.2A@24VDC
Fuse capacity 2.5A/30VDC, Polyswitch
Power
consumption
6W
Insulation
resistance
> 5MΩ (all I/O point-to-ground: 500VDC)
Noise immunity
ESD (IEC 61131-2, IEC 61000-4-2): 8kV Air Discharge
EFT (IEC 61131-2, IEC 61000-4-4): Power Line: 2kV, Digital I/O: 1kV,
Analog & Communication I/O: 1kV
Damped-Oscillatory Wave: Power Line: 1kV, Digital I/O: 1kV
RS (IEC 61131-2, IEC 61000-4-3): 26MHz ~ 1GHz, 10V/m
Grounding
The diameter of grounding wire shall not be less than that of the wiring
terminal of the power. (When PLCs are in use at the same time, please
make sure every PLC is properly grounded.)
Operation /
storage
Operation: 0ºC ~ 55ºC (temperature); 5 ~ 95% (humidity);
pollution degree 2
Storage: -25ºC ~ 70ºC (temperature); 5 ~ 95% (humidity)
Agency approvals
UL508
European community EMC Directive 89/336/EEC and Low Voltage
Directive 73/23/EEC
Vibration /
shock immunity
International standards: IEC61131-2, IEC 68-2-6 (TEST Fc)/IEC61131-2 &
IEC 68-2-27 (TEST Ea)
Weight (g) 260 260 240 240 230
Input Point
Spec.
Items
24VDC single common port input
200kHz 10kHz
Input No.
X0, X1, X4, X5,
X10, X11, X14, X15
#1
X2, X3, X6, X7, X12, X13, X16,
X17
Input voltage (±10%) 24VDC, 5mA
Input impedance 3.3kΩ 4.7kΩ
Action level
OffOn > 5mA (16.5V) > 4mA (16.5V)
OnOff < 2.2mA (8V) < 1.5mA (8V)
Response
time
OffOn < 150ns < 8μs
OnOff < 3μs < 60μs
Filter time Adjustable within 10 ~ 60ms by D1020, D1021 (Default: 10ms)
Note: 24SV2 does not support X12~X17.
#1: For products with a hardware version later than A2, the inputs X10, X11, X14, X15 should be
operated at the 200kHz rate. The firmware + hardware version can be found on the sticker
label of the product, e.g. V2.00A2.
Output Point
Spec.
Items
Relay
Transistor
High-speed Low-speed
Output No. Y0 ~ Y7, Y10 ~ Y13 Y0 ~ Y4, Y6 Y5, Y7, Y10 ~ Y13
Max. frequency 1Hz 200kHz 10kHz
Working voltage 250VAC, < 30VDC 5 ~ 30VDC
#1
Max. load Resistive 1.5A/1 point (5A/COM)
0.3A/1 point @ 40˚C
Max. load
Inductive
#2
9W (30VDC)
Lamp 20WDC/100WAC 1.5W (30VDC)
Response
time
OffOn
Approx. 10ms
0.2μs 20μs
OnOff 0.2μs 30μs
#1: For a PNP output model, UP and ZP must be connected to a 24VDC (-15% ~ +20%) power
supply. The rated consumption is 10mA/point.

Delta DVP28SV11R Specifications

General

Brand	Delta
Model	DVP28SV11R
Category	I/O Systems
Language	English