DVP-ES3 Series Operation Manual
Email
Click Email to set the email-related functions. The system sends email to the set email address after you enable the
email function. You can set up to four sets of conditions for sending email to up to four groups of email addresses.
Select Email Function Enable to enable the function.
Set an IP address of the SMTP server. Set the COM port of SMTP server at the COM port and set the sender’s
local email address. Type the Mail Subject to appear at the start of the subject of every email.
Select Account identification checkbox to enable the function to authenticate the connection with a user name
and a password when logging into an SMTP server.
Type the target email addresses.
Click 1
st
Trigger Setting and type a trigger name in Trigger Name box and a minimum interval in Trigger Min Cycle.
Then select a trigger condition in the Trigger Mode list. When the sending condition is met, the system sends an email
every designated period of time. The system does not send the same email again.
To Next Page
Loading...
Need help?
General
