DVP-ES3 Series Operation Manual
A-6
A.2 Installing the USB Driver for DVP-ES3 Series CPU Module
This section describes the steps to install the USB driver for a DVP-ES3 Series CPU module on Windows 10.
To install the USB driver for a DVP-ES2 Series CPU module on another operating system, refer to the
instructions in the operating system for information about installing new hardware.
Before you install the USB driver, you must install ISPSoft version 3.00 or above on your computer.
Supply power to the DVP-ES3 Series CPU module. Connect the DVP-ES3 Series CPU module to a USB port
on the computer with a USB cable.
(1) Windows detects the module. From the Windows Control Panel, open the Device Manager. The name of
the USB device appears in the Device Manager window. Double-click DVP-ES3.
To Next Page
Loading...
Need help?
General
