Delta E Series - Inverter Turn-On Procedure; Inverter Turn-Off Procedure

52
Dark start
5.3 Inverter turn-on procedure
1. Turn on the DC disconnect (turn to “ON” position, if rapid shutdown device is connected
turn on AC disconnect rstly).
2. Check for inverter initialization (all ve LED indicators are illuminated).
3. Turn on the dedicated 2-polo 240Vac / 208Vac circuit breaker in the building electrical
service panel (put in closed position).
4. If there is AC disconnect, turn on the AC disconnect.
5. Refer to section 6 for setup process that needs to be completed before the inverter can
begin feeding power to the grid.
5.4 Inverterturn-o󰀨procedure