Delta MultiChoice 17 Series Manual

107529 Rev. F
Connect valve body to water supplies using
the proper fittings for your valve body type
(copper tubing, iron pipe or Pex). Note: (1) is
the cold inlet port and (2) is the hot inlet
port. If either of the two outlet ports is to be
unused, seal the port with a pipe plug.
Remove bonnet (1). Warning: Avoid
soldering at high temperatures.
Be sure stops (2) are removed from the
w/stops version before soldering. (Do not
install stops before soldering.)
If you are making a back to back or
reverse installation (hot on right and
cold on left) install the valve body as
described, but the water supply lines will
be reversed. Note: (1) is the hot inlet
port and (2) is the cold inlet port.
Copper Tubing Iron Pipe
Pex
C.
1
2
1
2
1
2
D.
1
2
4

Delta MultiChoice 17 Series Specifications

General

Series	17 Series
Material	Brass
Handle Type	Lever
Diverter Location	Integrated
ADA Compliant	Yes
WaterSense Certified	Yes
Flow Rate	2.5 GPM
Installation	Wall Mounted
Cartridge	Dual-function pressure balance cartridge
Valve Type	Pressure Balance
Temperature Control	Thermostatic
Finish	Varies by trim kit