107533 Rev. C
MultiChoice
®
Valve Trim
with Diverter
Installation Instructions
Owners Manual
T27T Models
Write purchased model number here.
T
E
F
L
O
N
You May Need
Table of Contents:
Warranties ................................................................................. Page 2
Installation Instructions ............................................................. Pages 3 - 7
Clean and care........................................................................... Page 7
Maintenance .............................................................................. Page 7
Cartridge Summary Reference Sheet ....................................... Page 7
To order replacement parts, visit www.deltafaucet.com
CAUTION: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION!–As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary temperature knob adjustments
at
the time of installation and further adjustments
may be necessary due to seasonal water
temperature change. YOU MUST inform the
owner/user of this requirement by following the
instructions. If you or the owner/user are unsure
how to properly make these adjustments please
refer to page 5 and if still uncertain, call us at
1-800-345-DELTA.
After installation and adjustment, you must ax
your name, company name and the date you
adjusted the temperature knob to the caution
label provided and apply or attach the label to
the back side of the closest cabinet door and
the warning label to the water heater. Leave
this Instruction Sheet for the owner’s/user’s
reference. WARNING: This pressure balanced
or thermostatic bath valve is designed
to minimize the eects of outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the plumbing
system, if the temperature knob is not properly
set or if the hot water temperature is changed
after the settings are made or if the water inlet
changes due to seasonal changes. WARNING:
Do not install a shut-o device on either outlet
of this valve. When this type of device shuts
o the water ow, it can defeat the ability of
the valve to balance the hot and cold water
pressures.
10/20/2020
1
107533
T27T ModelsT27T ModelsT27T Models
To Next Page
Need help?
General
