4
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The fan is not
turning ON
1.
2. Faulty switch
3. Faulty wire connection
1. Make sure power supply is on.
2. Test or replace switch.
3. Check wire in switch box.
The fan seems louder
than it should
1. CFM too great
2. Damper not working
properly or damaged
3. Bend in duct too close
to fan discharge
4. Fan discharge duct
5. Fan body not securely
attached
1. Be sure the CFM rating on the fan matches
the size of your room.
2. Check damper to ensure it is opening and
closing properly. If the damper has become
damaged, please call Customer Service.
3. Be sure you do not have any sharp bends in
duct closer than 18 in. to the fan discharge.
4. Use recommended size ducting to reduce
fan noise.
5. Be sure the fan is securely attached to your
ceiling joists.
The fan is not clearing
the room
1.
airfow within room
2.
1. Be sure a door or window is slightly ajar or
to draw air out of the room without enough
2. Be sure the CFM rating on the fan matches
the requirements for your room size.
The fan keeps running
even though the house
humidity level is lower
than 60% RH
1. Our sensor tolerance
is +/-10% RH
2. Outdoor humidity is
back drafting to the fan
3. Indoor temperature
level
1. Continue to let the fan run since it is good to
keep venting the house and the electric bill
is minimal (approximately less than $10 per
year).
2.
The light is not
turning ON
1.
2. Faulty switch
3. Faulty wire connection
1. Make sure power supply is on.
2. Test or replace switch.
3. Check wire in switch box.
DIMENSIONS
Unit: Inch
8"
8
1
4
"
4"
5
3
4
"
10
3
4
"
10
3
4
"
WARRANTY
DELTA ELECTRONICS THREE YEAR LIMITED WARRANTY
Delta Electronics Inc. (“Delta Electronics”) warrants to the
original consumer purchaser in the USA that the Breez
ventilation fan products will be free from defects in material or
workmanship. This warranty is limited to three (3) years from
the original date of purchase.
Limitations and Exclusions
1. During the warranty period, a replacement for any
defective product will be supplied free of charge for
installation by the consumer. The warranty provided
herein does not cover charges for labor or other costs
incurred in the troubleshooting, repair, removal, and
installation service.
2. All returns of defective parts or products must include
the product model number, and must be made through
an authorized Delta Electronics distributor. Authorized
returns must be shipped prepaid. Repaired or
replacement products will be shipped by Delta Electronics
F.O.B. shipping point.
3. Delta Electronics shall not be liable for any indirect,
incidental, consequential, punitive, or special damages
arising out of or in connection with products use or
performance, regardless of the form of action whether in
contract, tort (including negligence), strict product liability
or otherwise.
Address: 46101 Fremont Boulevard, Fremont, CA 94538
US Toll Free Number:
1-888-979-9889 – Technical Support
1-877-685-4384 – Customer Sales Support
www.deltabreez.com
PRODUCT SPECIFICATIONS
Model No.
Voltage
(V)
Frequency
(Hz)
Air Flow
@ 0.1"SP
(CFM)
Power
@ 0.1"SP
(W)
Max
Current
(Amps)
Weight
(lb.)
Note Light Spec
80LED-ADJ/
VFB080C4LED2-A
120 60 80 11.0 0.33 6.0
Single
Speed
13W LED,
850 Lumens,
2700K
4000K
5000K
80HLED /
VFB80HLED2
120 60 80 11.0 0.33 6.1
13W LED,
850 Lumens,
3000K
80LED /
VFB080C4LED2
120 60 80 11.0 0.33 6.0
Single
Speed
13W LED,
850 Lumens,
3000K
100HLED /
VFB100HLED2
120 60 100 13.6 0.35 6.3
13W LED,
850 Lumens,
3000K
100LED /
VFB100C4LED1
120 60 100 13.6 0.35 6.2
Single
Speed
13W LED,
850 Lumens,
3000K
501622290005
4. The warranty does not cover if user does not comply with
manufacturer’s installation manual.
5. To qualify for warranty service, you must notify Delta
Electronics at the address or telephone number below.
6. Delta Electronics shall have no liability to the original
owner-user with respect to any defect caused by abuse,
misuse, neglect, improper transportation or storage,
improper testing, improper installation, improper
operation, improper use, improper maintenance, improper
tampering or accident of products or parts thereof, or
unusual deterioration or degradation of products or
parts thereof due to a physical environment beyond the
Humidity
Sensing
Humidity
Sensing
To Previous Page
Loading...
Need help?
General