Chapter 10 Digital KeypadCP2000
10-7
(Pr.01-11)
21. Acceleration time 1 (Pr.01-12)
22. Deceleration time 1 (Pr.01-13)
23. Over-voltage stall prevention
(Pr.06-01)
24. Derating protection (Pr.06-55)
25. Speed tracking during start-up
(Pr.07-12)
26. Emergency stop (EF) & force to stop
selection (Pr.07-20)
27. Torque command filter time
(Pr.07-24)
28. Slip compensation filter time (Pr.07-25)
29. Torque compensation gain (Pr.07-26)
30. Slip Compensation Gain (Pr.07-27)
2. SVC Mode
01: Password Decoder
Items
1. Parameter protection password input
(Pr.00-07)
2. Parameter protection password setting
(Pr.00-08)
3. Speed control mode (Pr.00-11)
4. Load selection (Pr.00-16)
5. Carrier frequency (Pr.00-17)
6. Master frequency command (AUTO)
source / Source selection of the PID
target (Pr.00-20)
7. Operation command (AUTO) source
(Pr.00-21)
8. Stop method (Pr.00-22)
9. Digital keypad STOP function
(Pr.00-32)
10. Max. operation frequency (Pr.01-00)
11. Output frequency of motor 1
(Pr.01-01)
12. Output voltage setting of motor 1
(Pr.01-02)
13. Min. output frequency of motor 1
(Pr.01-07)
14. Min. output voltage of motor 1
(Pr.01-08)
15. Output frequency upper limit
(Pr.01-10)
16. Output frequency lower limit
(Pr.01-11)
17. Acceleration time 1 (Pr.01-12)
18. Deceleration time 1 (Pr.01-13)
19. Full-load current for induction motor 1
(Pr.05-01)
20. Rated power for induction motor 1
(Pr.05-02)
21. Rated speed for induction motor 1
(Pr.05-03)
22. Number of poles for induction motor 1
(Pr.05-04)
23. No-load current for induction motor 1
(Pr.05-05)
24. Over-voltage stall prevention
(Pr.06-01)
25. Over-current stall prevention during
acceleration (Pr.06-03)
26. Derating protection (Pr.06-55)
27. Emergency stop (EF) & Force to stop
selection (Pr.07-20)
28. Torque command filter time
To Next Page
Loading...