Chapter 12 Descriptions of Parameter SettingsC2000 Plus
12.1-01-41
2: When switching between LOCAL and REMOTE, the drive runs with
REMOTE settings for frequency and operation status.
3: When switching between LOCAL and REMOTE, the drive runs with LOCAL
settings for frequency and operation status.
4: When switching between LOCAL and REMOTE, the drive runs with LOCAL
settings when switched to Local and runs w
ith REMOTE settings when
switched to Remote for frequency and operation status.
The default of Pr.00-29 is 0, that is, the standard (Hand-Off-Auto) function. Set the AUTO
frequency and operation source with Pr.00-20 and Pr.00-21. Set the HAND frequency and
operation source with Pr.00-30 and Pr.00-31. Select or switch AUTO / HAND mode by using the
digital keypad (KPC-CC01) or setting the multi-function input terminal MIx = 41, 42.
When you set the external terminal (MI) to 41 and 42 (AUTO / HAND mode), Pr.00-29 = 1,2,3,4
are disabled. The external terminal has the highest command priority, and Pr.00-29 functions in
standard HOA mode.
If Pr.00-29 is not set to 0, the Local / Remote function is enabled, and the top right corner of digital
keypad KPC-CC01 (optional) displays LOC or REM (the display is available when KPC-CC01 is
installed with firmware version higher than version 1.021). Set the LOCAL frequency and operation
source with Pr.00-20 and Pr.00-21. Set the REMOTE frequency and operation source with Pr.00-
30 and Pr.00-31. Select or switch LOC / REM mode with the digital keypad KPC-CC01 (optional)
or set the multi-function input terminal MIx = 56. The AUTO key of the digital keypad is for the
REMOTE function, and HAND key is for the LOCAL function.
When you set the external terminal (MI) to 56 for LOC / REM mode selection, if you set Pr.00-29
to 0, then the external terminal function is disabled.
When you set the external terminal (MI) to 56 for LOC / REM mode selection, if Pr.00-29 is not set
to 0, then AUTO / HAND keys are disabled. In this case, the external terminal has the highest
command priority.
The comparison between the setting of each mode and the PLC address:
PLC address /
mode
HOA mode LOC / REM mode HOA mode
HAND-ON AUTO-ON LOC-ON REM-ON OFF
M1090 = 0 0 0 0 1
M1091 = 1 0 0 0 0
M1092 = 0 1 0 0 0
M1100 = 0 0 1 0 0
M1101 = 0 0 0 1 0
00-30
Master Frequency Command Source (HAND)
Default: 0
Settings 0: Digital keypad
1: RS-485 communication input
2: External analog input (Refer to Pr.03-00–03-02)
3: External UP / DOWN terminal (multi-function input terminals)
To Next Page
Loading...