Chapter 12 Description of Parameter SettingsCP2000
12.1-09-18
Communication Card Gateway Address 4 (for Modbus TCP)
Default: 0
Settings 0–65535
Communication Card Password (Low word) (for Modbus TCP)
Communication Card Password (High word) (for Modbus TCP)
Default: 0
Settings 0–99
Reset Communication Card (for Modbus TCP)
Default: 0
Settings 0: Disable
1: Reset, return to default
Additional Setting for the Communication Card (for Modbus TCP)
Default: 1
Settings bit0: Enable IP Filter
bit1: Enable internet parameters (1bit)
When IP address is set, this bit is enabled.
fter updating the
communication card parameters, this bit changes to disabled.
bit2: Enable login password (1bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to disable.
Communication Card Status (for Modbus TCP)
Default: 0
Settings bit0: Enable password
When the communication card is set with a password, this bit is
enabled. When the password is cleared, this bit is disabled.
To Next Page
Loading...
Need help?
General