16: Rotating speed command from ACI
18: Force to stop (Pr.07-20)
19: Digital up command
20: Digital down command
21: PID function disabled
22: Clear the counter
23: Input the counter value (MI6)
24: FWD JOG command
25: REV JOG command
26: TQC / FOC mode selection
27: ASR1 / ASR2 selection
28: Emergency stop (EF1)
29: Signal confirmation for Y-connection
30: Signal confirmation for -connection
31: High torque bias (Pr.11-30)
32: Middle torque bias (Pr.11-31)
33: Low torque bias (Pr.11-32)
38: Disable writing EEPROM function
39: Torque command direction
40: Force coasting to stop
41: HAND switch
42: AUTO switch
48: Mechanical gear ratio switch
49: Enable drive
50: Slave dEb action to execute
51: Selection for PLC mode bit 0
52: Selection for PLC mode bit 1
53: Trigger CANopen quick stop
56: Local / Remote selection
58: Enable fire mode (with RUN command)
59: Enable fire mode (without RUN command)
70: Force auxiliary frequency return to 0
71: Disable PID function, force PID output return to 0
72: Disable PID function, retain the output value before
disabled
73: Force PID integral gain return to 0, disable integral
74: Reverse PID feedback
81: Simple positioning zero point position signal input
82: OOB loading balance detection
83: Multi-motor (IM) selection bit 0
To Next Page
Loading...
Need help?
General