Delta VFD25AMS23ANSAA

Chapter 11 Summary of Parameter SettingsMS300
250
Pr.
Explanation
Settings
Default

09-85
Communication Card
Gateway Address 2
(for EtherNet)
0–255
0

09-86
Communication Card
Gateway Address 3
(for EtherNet)
0–255
0

09-87
Communication Card
Gateway Address 4
(for EtherNet)
0–255
0

09-88
Communication Card
Password (Low Word)
(for EtherNet)
0–99
0

09-89
Communication Card
Password (High Word)
(for EtherNet)
0–99
0

09-90
Reset Communication Card
(for EtherNet)
0: Disable
1: Reset to defaults
0

09-91
Additional Settings for the
Communication Card
(for EtherNet)
bit 0: Enable IP filter
bit 1: Enable internet parameters (1 bit)
When the IP address is set, this bit is enabled.
After updating the parameters for the
communication card, this bit changes to disabled.
bit 2: Enable login password (1 bit)
When you enter the login password, this bit is
enabled. After updating the communication card
parameters, this bit changes to disabled.
0
09-92
Communication Card Status
(f+or EtherNet)
bit 0: Enable password
When the communication card is set with a
password, this bit is enabled. When the password
is cleared, this bit is disabled.
0