Delta WHITEWATER DF Series - ELECTRICAL REQUIREMENTS; TREATMENT PLANT DIMENSIONS

Delta Treatment Systems • 9125 Comar Drive, Walker, LA 70785 • 1-800-219-9183 • www.deltatreatment.com
17
MODEL COMPRESSOR
MOTOR FULL
LOAD AMPS
MEASURED
OPERATING WATTS
ELECTRICAL
REQUIREMENTS
DF-50 Delta Model 60
AP60
Delta Model 80
AP80
1.75
1.75
2.1
2.1
63
63
85
85
115 volt – single phase
DF-60 AT05
5100S
Delta Model 80
AP80
Delta Model 100
4.6
2.71
2.1
2.1
2.71
449
110
85
85
110
115 volt – single phase
DF-75 5100S
5120S
AT05
Delta Model 100
Delta Model 120
2.71
2.8
4.6
2.71
2.8
110
157
449
110
157
115 volt – single phase
DF-100 (1) 0823
(2) Delta Model 80
(2) AP80
(1) 10.4
(2) 2.1
(2) 2.1
(1) 640
(2) 85
(2) 85
115 volt – single phase
DF-150 (3) 5100S
(1) 1023
(2) 5120S
(3) Delta Model 100
(2) DELTA MODEL 120
(3) 2.71
(1) 10.4
(2) 2.8
(3) 2.71
(2) 2.8
(3)110
(1) 850
(2)157
(3) 110
(2) 157
115 volt – single phase
SPECIFICATIONS
ELECTRICAL REQUIREMENTS
TREATMENT
PLANT
A B C D E F G
DF50 4' 11-3/16" 4' 8-3/16" 6' 0" 4' 5-9/16" 5' 0" 10" 6' 6"
DF60 5' 7-3/4" 5' 4" 6' 3" 5' 1-1/2" 5' 9" 11-1/2" 6' 9"
DF75 6' 0-1/2" 5' 8-1/2" 6' 9" 5' 6" 6' 2" 11-1/2" 7' 3"
DF100A 5' 9-5/8" 5' 6" 8' 0" 5' 3" 6' 0" 1' 0" 8' 6"
DF150 8' 3-5/8" 8' 0" 8' 0" 7' 9-1/2" 8' 6" 1' 3-3/4" 8' 6"
Refer to treatment plant drawings, pages 18 and 19, on the above dimensions.
Note: For special cargo or container shipments 12 inches must be added to the diameters of all berglass units (due to the
berglass ange and lifting lugs).