Demtech Pro-Wedge XL - Page 2

Rev. D, January 2021

Pro-Wedge XL Operator’s Manual ii

© Copyright 2020 by DEMTECH Services, Inc.
All Rights Reserved
Scope of Manual:
This manual contains procedures for safety, general unpacking,
set-up, and operation of your DEMTECH Services, Inc. Pro-Wedge.
The text of this publication, or any part thereof, may not be reproduced or transmitted in any
form or by any means, electronic or mechanical, including photocopying, recording, storage in
an information retrieval system, or otherwise, without prior written permission of DEMTECH
Services, Inc.
Any software program contained within the Pro-Wedge for operation of the welder is protected
by copyright laws that pertain to computer software. Use of this software does not authorize de-
compiling, disassembling or reverse engineering to gain access to the program code.
DEMTECH Services, Inc. does not authorize any copying, changing, or other use of this
software.
Notice
Patents have been granted and/or patent applications are pending or are in the process of
preparation on all DEMTECH Services, Inc. developments.
The material in the manual is for informational purposes only and is subject to change without
notice.
DEMTECH Services, Inc. assumes no responsibility for any errors that may appear in this
manual.
Manual Number: 500-OPERATOR’S MANUAL/3XL, Revision: D
DEMTECH Services, Inc.
6414 Capitol Avenue Diamond Springs, CA 95619 U.S.A.
Telephone: (530) 621-3200
Toll Free: (888) 324-9353
Fax: (530) 621-0150
Web Site: www.demtech.com