Need help?Do you have a question about the DENAFRIPS ARES 12TH DAC and is the answer not in the manual?
General| Digital Inputs | USB, Coaxial, Optical, AES/EBU |
|---|---|
| Analog Outputs | RCA, XLR |
| Output Voltage (XLR) | 4.0 Vrms |
| Output Voltage (RCA) | 2.0 Vrms |
| THD+N | 0.0020% |
| Power Consumption | 20W |
| Weight | 3.5kg |
| Type | R-2R DAC |
| Architecture | R-2R Ladder |
| DAC Chips | Proprietary R-2R |
| USB Input Support | DSD1024 |
| Coax/Optical Input Support | PCM 16-24bit / 44.1, 48, 88.2, 96, 176.4, 192kHz |
| AES/EBU Input Support | PCM 16-24bit / 44.1, 48, 88.2, 96, 176.4, 192kHz |
| Frequency Response | 20Hz - 20kHz |
| AC Power Requirement | 100-240V, 50/60Hz |
| Dimensions | 215 x 230 x 45 mm |
Stores digital audio data in memory for jitter reduction using a precision FEMTO Clock.
High-end USB solution powered by STM32F446 MCU for PCM and DSD playback.
Utilizes FPGA for SPDIF decoding, shortening signal path for improved audio quality.
Allows users to switch between Non-Over-Sampling (NOS) and Over-Sampling (OS) modes.
Features 24Bit R-2R DAC and 32-step FIR filters for hardware decoding of PCM and DSD.
Details the digital signal processing, Femto Clock, and R-2R ladder network components.
Explains the front panel controls, buttons, and LEDs for basic operation.
Details OS/NOS modes, phase selection, and digital audio signal input sampling rates.
Describes how to access and set filter modes and I2S pin-out configurations.
Identifies the rear panel connections including digital inputs and analog outputs.
Provides instructions for downloading and installing the required USB audio driver on Windows.
To Next Page
