Need help?Do you have a question about the DENAFRIPS VENUS II and is the answer not in the manual?
Stores digital audio data in memory for jitter reduction.
Utilizes LVDS I2S input via HDMI for superior digital audio transfer.
High-end USB audio solution with advanced MCU for high-res PCM and DSD.
SPDIF receiver bypasses standard chips, using FPGA for cleaner digital audio.
Allows users to switch between Non-Oversampling (NOS) and Oversampling (OS) modes.
Employs 24Bit R-2R DAC for PCM and FIR filters for DSD decoding.
Details the digital signal processing, clocking, and R-2R ladder network.
Basic operation instructions for front panel controls and setup.
Table illustrating input sampling rate LED status for various formats.
Guides on how to select between Slow and Sharp filters in OS mode.
Instructions for enabling/disabling dual AES/EBU input.
Details on configuring the I2S input pinout via HDMI.
Step-by-step guide for installing the USB audio driver on Windows.
Guide to setting the DENAFRIPS USB DAC as the default audio device in Windows.
Lists compatible software for optimal playback with the DAC.
General| Digital Inputs | USB, Coax, Optical, AES/EBU, I2S |
|---|---|
| Analog Outputs | RCA, XLR |
| Dynamic Range | >130dB (A-weighted) |
| AC Power Requirement | 100V - 240V, 50/60Hz |
| Coax/Optical Input Support | PCM 24bits/44.1, 48, 88.2, 96, 176.4, 192KHz, DSD64-DoP |
| AES/EBU Input Support | PCM 24bits/44.1, 48, 88.2, 96, 176.4, 192KHz, DSD64-DoP |
To Next Page
