smartDEN IP-16R-XX User Manual
13 Apr 2021
10.1.5. Auto-reboot
Table 10.5. Auto-reboot settings
Auto-reboot Mode
Enable (Disabled-0,
Enabled-1)
DISPLAYSTRING
(SIZE (0..23))
Interval Between
Pings, sec (1..3600)
Ping Failures Before
Reboot (1..100)
Ping Delay After
Reboot, sec (1..3600)
Power-up Pulse
Enable (Disabled-0,
Enabled-1)
Power-up Pulse, sec
(1..3600)
Reboot Pulse1 Enable
(Disabled-0, Enabled-
1)
Reboot Pulse1,
sec (1..3600)
Pulse1ToPulse
2DelayEnable
Pulse1 To Pulse2
Delay Enable
(Disabled-0, Enabled-
1)
Pulse1 To Pulse2
Delay, sec (1..3600)
Reboot Pulse2 Enable
(Disabled-0, Enabled-
1)
Reboot Pulse2, sec
(1..3600)
10.2. Modbus TCP (for smartDEN IP-16R-MT only)
Modbus-TCP is an application layer messaging protocol, which provides
master/slave (client/server) communication between devices connected on Ethernet
networks. A Modbus-TCP message consists of a header (7 bytes) and the protocol
data unit, which is encapsulated by the transmitting device into a standard TCP
frame (Figure 10.1).