Settings AUDIO OUT connectors
Height
Sp
Dolby Sp NOTE Front Layout
Middle
Layout
Rear Layout HEIGHT 1 HEIGHT 2 HEIGHT 3
HEIGHT 4/
FRONT WIDE
8ch None
z3 z6
Front Height &
Center Height
Top Middle &
Top Surround
Rear Height Front Height Rear Height Top Middle
L: Top
Surround
R: Center
Height
6ch 2ch
z3 z6
Front Height &
Center Height
Surr. Dolby &
Top Surround
Rear Height Front Height Rear Height
Surround
Dolby
L: Top
Surround
R: Center
Height
z1
This can be selected when using Surround Back speakers.
z2
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup
in place of Surround Height speakers.
z3 This can be set when “Assign Mode” in the menu is set to “13.1ch” or “11.1ch”. (v p. 226)
z4
Use 2 sets of Height speakers in the appropriate sound modes for Dolby Atmos, DTS:X or Auro-3D playback.
Use the Front Height and Rear Height speakers for Dolby Atmos or DTS:X playback.
Use the Front Height and Surround Height speakers for Auro-3D playback.
z5 This can be set when “Assign Mode” in the menu is set to “13.1ch” or “11.1ch”, and “Floor” - “Layout” is set to “5ch” or “5ch & SB”. (v p. 229)
z6
This combination cannot be selected when Front Wide speakers are being used.
n
Settings
Select the signal to be output from the selected speaker terminal.
0
Only “Center” and “None” can be set for the CENTER speaker
terminal.
0
The HEIGHT4/FRONT WIDE speaker terminal is not used.
o
View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your “Amp Assign” setting on the menu screen.
Contents Connections Playback Settings Tips Appendix
235
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
