Setting the back light
You can set the back light on the remote control unit to off to prolong the
life of the dry cell batteries.
0
The default setting is “ON”.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “LIGHT” on the remote control unit
and press ENTER.
3
Use ui to set the back light and press ENTER.
Remote control unit display Back light
ON Back light on
OFF Back light off
Restoring all settings of the remote
control unit to default
All the settings are restored to their defaults.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “RESET” on the remote control unit
and press ENTER.
3
Use ui to display “ALL” on the remote control unit
and press ENTER.
4
Use ui to display “YES” on the remote control unit
and press ENTER.
“RESET” flashes four times on the remote control unit and the
normal operation mode is restored.
Contents Connections Playback Settings Tips Appendix
288
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
