Denon AVC-A110 User Manual

Resetting network settings
If network contents cannot be played or the unit cannot connect to the network, restarting the unit may improve the problem. We recommend restarting the
unit before returning the settings to the default settings. (v p. 292)
If the operations are not improved by restarting the unit, follow the steps below.
Network settings are reset to the factory default values. Make settings again.
However, the menu “Amp Assign”, “Speaker Config.” and “Video” settings are not reset.
.
SOURCE SELECT DIMMER
pX
1
Press X to turn on power to the unit.
2
Turn SOURCE SELECT to select “HEOS Music”.
3
Press and hold the main unit's DIMMER and p at the
same time for at least 3 seconds.
4
Remove your fingers from the two buttons when
“Network Reset...” appears on the display.
5
“Completed” is shown in the display when reset is
complete.
0
Before returning the settings to the default settings, use the “Save & Load” function
from the menu to save and restore the details of various settings configured on the
unit. (v p. 270)
NOTE
0
Do not turn the power off until reset is complete.
Contents Connections Playback Settings Tips Appendix
313
Front panel Display Rear panel Remote Index

Denon AVC-A110 Specifications

General

Type	AV Amplifier
Channels	13.2
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
HDMI Inputs	8
HDMI Outputs	3
Dolby Atmos	Yes
DTS:X	Yes
Auro-3D	Yes
IMAX Enhanced	Yes
8K/60Hz Pass-Through	Yes
4K/120Hz Pass-Through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
Bluetooth	Yes
Wi-Fi	Yes
Ethernet	Yes
USB Port	Yes
Power Output	150W (8 ohms, 20 Hz - 20 kHz, THD 0.05%, 2ch driven)
Frequency Response	10Hz-100kHz (+1, -3dB)
Multi-Room Audio	Yes (HEOS)