Denon AVC-A1H User Manual

o
TV Audio sharing settings
You can enjoy the same content as the MAIN ZONE in ZONE2 or
ZONE3 while maintaining surround playback of the content from TV or
other playback devices in the MAIN ZONE with the original audio
format such as Dolby Atmos.
By saving the following settings in advance to Quick Select, you can
easily call up the playback environments to be used in the MAIN
ZONE and ZONE2 or ZONE3 with this function.
1
Select the input source to play back in the MAIN ZONE.
2
Press ZONE2 ON/OFF or ZONE3 ON/OFF on the main
unit to turn on the power of ZONE2 or ZONE3.
3
Press ZONE2 SOURCE or ZONE3 SOURCE on the main
unit to switch the input source of ZONE2 or ZONE3 to
“Source”.
If “Source” is selected as the input source of ZONE2 or ZONE3, the
input source is changed to mirror that of the MAIN ZONE.
4
Press and hold the desired QUICK SELECT until “Quick
Select* Memory” appears on the display.
Contents Connections Playback Settings Tips Appendix
147
Front panel Display Rear panel Remote Index

Denon AVC-A1H Specifications

General

Channels	15.4
Power Output	150W per channel (8 ohms, 20Hz-20kHz, 0.05% 2ch Drive)
HDMI Outputs	3
Audio Formats	Dolby Atmos, DTS:X, Auro-3D, IMAX Enhanced
Wireless Connectivity	Wi-Fi, Bluetooth
Type	AV Amplifier
IMAX Enhanced	Yes
8K/60Hz Pass-through	Yes
4K/120Hz Pass-through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
THD	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
Ethernet	Yes
USB Port	Yes
Multi-Room Audio	HEOS
Amplifier Type	Class AB