EasyManuals Logo

Denon AVC-A1H User Manual

Denon AVC-A1H
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
o
About the main listening position
The main listening position is the position where listeners would
normally sit or where one would normally sit alone within the listening
environment. Before starting Audyssey
®
Setup, place the Sound
calibration microphone in the main listening position.
Audyssey MultEQ
®
XT32 uses the measurements from this position to
calculate speaker distance, level, polarity, and the optimum crossover
value for the subwoofer.
o
About Audyssey Sub EQ HT™
The Audyssey Sub EQ HT™ performs corrections based on the
volume level and the distances of multiple subwoofers, and processes
the Audyssey MultEQ
®
XT32 signal to reproduce a powerful low
frequency sound.
To run Audyssey Sub EQ HT™ you must set “Measure (2 spkrs)”,
“Measure (3 spkrs)” or “Measure (4 spkrs)” and set “Subwoofer Mode”
to “Standard” in “Channel Select”. (v p. 205).
0
Audyssey Sub EQ HT will not work when “Subwoofer Mode” is set to
“Directional”.
NOTE
0
Make the room as quiet as possible. Background noise can disrupt the room
measurements. Close windows and turn off the power on electronic devices
(radios, air conditioners, fluorescent lights, etc.). The measurements could be
affected by the sounds emitted by such devices.
0
During the measurement process, place cell phones outside the listening room.
Cell phone signals could disrupt the measurements.
0
Do not stand between the speakers and Sound calibration microphone or allow
obstacles in the path while the measurements are being made. Also, install the
Sound calibration microphone at least 50 cm away from the wall. Failure to do so
will result in inaccurate readings.
0
During the measurement process, audible test tones will come from the speakers
and subwoofer(s), but this is part of normal operation. If there is background noise
in the room, these test signals will increase in volume.
0
Operating VOLUME d f on the remote control unit or MASTER VOLUME on the
main unit during the measurements will cancel the measurements.
0
Measurement cannot be performed when headphones are connected. Unplug the
headphones before performing Audyssey
®
Setup.
Contents
Connections Playback Settings Tips Appendix
203
Front panel Display Rear panel Remote Index

Other manuals for Denon AVC-A1H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVC-A1H and is the answer not in the manual?

Denon AVC-A1H Specifications

General IconGeneral
Channels15.4
Power Output150W per channel (8 ohms, 20Hz-20kHz, 0.05% 2ch Drive)
HDMI Outputs3
Audio FormatsDolby Atmos, DTS:X, Auro-3D, IMAX Enhanced
Wireless ConnectivityWi-Fi, Bluetooth
TypeAV Amplifier
IMAX EnhancedYes
8K/60Hz Pass-throughYes
4K/120Hz Pass-throughYes
HDR SupportHDR10, HDR10+, Dolby Vision, HLG
eARCYes
Phono InputYes
THD0.05%
Frequency Response10 Hz - 100 kHz
Input Sensitivity200 mV
Signal-to-Noise Ratio102 dB
EthernetYes
USB PortYes
Multi-Room AudioHEOS
Amplifier TypeClass AB

Related product manuals