Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey
®
Setup.
0
If you enable new speakers in the speaker configuration menu after
performing Audyssey
®
Setup, you will no longer be able to select
Audyssey MultEQ
®
XT32, Audyssey Dynamic EQ
®
or Audyssey
Dynamic Volume
®
. (v p. 181)
0
Changing the following settings:
Speaker size (Large or Small) / Distances / Levels / Crossovers settings
will not disable Audyssey
®
or require running Audyssey
®
Setup again.
0
“Manual Setup” can be used without changing the settings. Please set if
necessary.
Amp Assign
Select the power amplifier usage method to match your speaker system.
o
Assign Mode
Select how to use the power amp.
You need to configure the detailed settings for the speaker
configuration in accordance with the selected mode. Select Assign
Mode configure the corresponding detailed settings.
15.1ch
(Default):
0
Settings to assign all power amplifier
within this unit to MAIN ZONE to play
back up to 15.1-channels.
0
You can connect speakers for up to 17.1-
channels for MAIN ZONE.
The speaker output automatically switches
for playing back up to 15.1-channels in
accordance with the input signal and sound
mode when 17.1-channel speakers are
installed.
13.1ch + ZONE2:
0
Setting to assign the power amplifiers in
this unit for ZONE2 to 2-channels.
0
You can connect speakers for up to 13.1-
channels for MAIN ZONE.
Contents Connections Playback Settings Tips Appendix
213
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
