Denon AVC-A1H User Manual

Setting the back light of the remote control unit
SETUP
Light button
You can turn off the backlight of the remote control unit.
0
Backlight is set on in the factory settings.
Disabling the backlight
1
Press and hold both SETUP and Light button until the
MAIN, ZONE2 and ZONE3 indicators on the remote are
flashing green, then release.
0
The backlight function can be turned on by performing step 1 again while the
backlight function is off.
Contents Connections Playback Settings Tips Appendix
268
Front panel Display Rear panel Remote Index

Denon AVC-A1H Specifications

General

Channels	15.4
Power Output	150W per channel (8 ohms, 20Hz-20kHz, 0.05% 2ch Drive)
HDMI Outputs	3
Audio Formats	Dolby Atmos, DTS:X, Auro-3D, IMAX Enhanced
Wireless Connectivity	Wi-Fi, Bluetooth
Type	AV Amplifier
IMAX Enhanced	Yes
8K/60Hz Pass-through	Yes
4K/120Hz Pass-through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
THD	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
Ethernet	Yes
USB Port	Yes
Multi-Room Audio	HEOS
Amplifier Type	Class AB