Denon AVR-S540BT Service Manual

2. Video Format and Display Language change mode
2.1. Actions
Select or change "NTSC" or "PAL". Select or change the language.
2.2. Starting up
While the power is On, hold down buttons "
TUNE -
", "
TUNE +
" and "
DIMMER
" for at least 3 seconds.
2.3. Displaying and Selecting Each Mode
Pressing the button each time switches the display shown as follows.
V.Format:<****>
"
STATUS
"
Lang.:<*******>
q
Select Video Format
V.Format:<NTSC>
"
TUNER PRESET CH +
" or "
DIMMER
"
V.Format:<PAL>
Press the "
TUNE -
" button to conrm the displayed mode.
Do not turn off the power until the display switches to the normal mode screen.
w
Select Display Language
Lang.:<ENGLISH>
· E2, E1C model
"
TUNER PRESET CH +
" or "
DIMMER
"
Lang.:<SPANISH>
· E2 model
"
TUNER PRESET CH +
" or "
DIMMER
"
Lang.:<FRENCH >
· E2 model
"
TUNER PRESET CH +
" or "
DIMMER
"
Lang.:<CHINESE>
· E1C model
Press the "
TUNE -
" button to conrm the displayed mode.
Do not turn off the power until the display switches to the normal mode screen.
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
70

Denon AVR-S540BT Specifications

General

Channels	5.2
Power Output per Channel	70 W (8 ohm, 20 Hz - 20 kHz, 0.08% 2ch Drive)
Output Power (6 ohm, 1 kHz, 0.7% 2ch Drive)	90 W
Output Power (6 ohm, 1 kHz, 10% 1ch Drive)	140 W
HDMI Inputs	5
HDMI Outputs	1
HDMI Version	2.0a
HDCP Support	2.2
4K/60 Hz Pass-through	Yes
Dolby Format	Dolby TrueHD, Dolby Digital Plus
DTS Format	DTS-HD Master Audio
Auto Speaker Setup	Yes (Audyssey MultEQ)
Bluetooth	Yes
FM Tuner	Yes
AM Tuner	Yes
Input Sensitivity/Impedance	200 mV / 47 kOhm
Dimensions (W x H x D)	434 x 151 x 319 mm
Ethernet Port	No
Wi-Fi	No
HDR Support	HDR10, HLG
Frequency Response	10 Hz - 100 kHz - +1/-3 dB
Total Harmonic Distortion	0.08% (20 Hz - 20 kHz)
Signal-to-Noise Ratio	98 dB (IHF-A weighted)
USB Port	Yes (Front)