o
Layout
n
Configuration
Set the speaker layout when installing 1 set (2-channels) of Height, Ceiling or Dolby Atmos Enabled speakers.
The layouts that can be selected differ depending on the combinations of “Amp Assign” and floor speaker settings in the menu. (“Amp
Assign” (v p. 226), “Front/Center/Surround/Surround Back/Front Wide” (v p. 228))
[2-channel height speakers]
Settings AUDIO OUT connectors
Height Speakers Layout HEIGHT 1 HEIGHT 2
None - - -
2 spkrs
Front Height Front Height -
Top Front Top Front -
Top Middle Top Middle -
Top Rear Top Rear -
Rear Height Rear Height -
Front Dolby Front Dolby -
Surround Dolbyz1
Surround Dolby -
Back Dolbyz2
Back Dolby -
z1 This can be selected when using Surround speakers. Set “Surround” in the menu to “Yes”. (v p. 228)
z2 This can be selected when using two Surround Back speakers. Set “Surround Back” in the menu to “2 spkrs”. (v p. 228)
Contents
Connections Playback Settings Tips Appendix
230
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
